Scirocco Central

Hello

Firstly, thanks for adding me to the forum. I'm a proud owner of a 2010 Scirocco 2.0 TDI.

Recently I had the electric window motor die on the drivers side. Ever since the motor was replaced the wind noise on that side has been terrible. I notice that the window isn't sealing properly. It needs to be bought up by a couple mm.

Question. How do I adjust the window up vertically a few mm? I know you can adjust the tilt on the window from the bottom of the door via two bolts however its the vertical position I'm after. I have removed the door card but can't see anything obvious.

Thanks in advance
Ed

hi there. i have the same problem but i ordered the the window mechanism as my motor its still working. ill let you know how things went in my case.

Have you tried resetting the window positions?
Do the following:
- Sit in the car with the doors closed
- Switch the ignition on
- Open the window a few inches
- Close the window with the switch all the way in one go and without letting go of the switch continue to hold in the "Up" position for a couple of seconds
- Release the switch and wait a second
- Hold the switch in the "Up" position for a few seconds
- The window should now operate correctly

PGN wrote:Have you tried resetting the window positions?
Do the following:
- Sit in the car with the doors closed
- Switch the ignition on
- Open the window a few inches
- Close the window with the switch all the way in one go and without letting go of the switch continue to hold in the "Up" position for a couple of seconds
- Release the switch and wait a second
- Hold the switch in the "Up" position for a few seconds
- The window should now operate correctly

my case hasn't work...

i got my regulator today and i replace the old one and in my case the old regulator was broken but somehow still worked but wouldn't close the window completely. after replacing the regulator window closes all the way up its just now it need some alignment