Playing round with my MFA i came across 'E-MFA' display which shows oil temp, water temp, speed, accurate engine revs, speed and boost pressure.
Thinking this was pretty cool, i drove around a bit and noticed the boost bar reading was showing 0.00 pressure.
I know there is no issue with the turbo so its got to be a sensor issue. Does anyone know if these are hard or expensive to replace?
Also, showing my naivety, what should running temps of water and oil be?
Boost Bar Sensor
-
TheRustySheriff
- Posts: 62
- Joined: Sat Apr 25, 2015 8:06 pm
- I drive a: GT 2.0 TSI
- In: Deep Black
- With a: Manual box
-
owen191
- Posts: 30
- Joined: Tue Mar 10, 2015 7:52 pm
- I drive a: GT 2.0 TSI
- In: Candy White
- With a: Manual box
Re: Boost Bar Sensor
Not sure about the sensor.... Water temp should be around 90, oil should be about 100-105 when properly hot.