New Roc Owner - 2.0 TSI GT Deep Black

[Lloydyboy]

First post -

Just went and brought this...





Pick her up in a few weeks time so will get more pics then

[Lloydyboy]

Brought her home! Will get some decent pictures at the weekend

[scott.taylor]

I want your car.

I'm going to see about it today. Want to trade in my 122 for a Black 2.0TSi with DSG.

Looks so good in Black btw I need one !

[Lloydyboy]

[Lloydyboy]

First addition...

[alanr]

looks great bet your well please , how much and where from did you buy the sirocco sill or footplates from

thanks

[Lloydyboy]

Cheers Alan, yeah I'm really please with them. I personally felt the door sills are massive so good to get some protection on them.

I got them from this thread;

http://www.sciroccocentral.co.uk/forum/ ... =20&t=5134" onclick="window.open(this.href);return false;

however I believe you can find them on eBay as well.

http://www.ebay.co.uk/itm/09-10-11-VW-S ... _537wt_648" onclick="window.open(this.href);return false;

Hope that helps mate.

[GeoffCapes]

Looks good mate, enjoy it

[alanr]

Cheers Alan, yeah I'm really please with them. I personally felt the door sills are massive so good to get some protection on them.

I got them from this thread;

http://www.sciroccocentral.co.uk/forum/ ... =20&t=5134" onclick="window.open(this.href);return false;

however I believe you can find them on eBay as well.

http://www.ebay.co.uk/itm/09-10-11-VW-S ... _537wt_648" onclick="window.open(this.href);return false;

Hope that helps mate.

thanks for info , did you find them easy to fit ?

[happymum67]

They are self adhesive alanr

[Lloydyboy]

Yeah mate really easy to fit...just followed these instructions from that other thread;

Door Sills Installation instructions:
1-install at room temperature
2-remove all dirt, water, moisture and grease from the paint surface (suggest to use "Robinson" lighter fluid for lighter)
3-mark designated position with the sill
4-There are 5 pieces of double-side tape at the back:
A)small pieces at both end x 2
B)thin long piece along the sill x2
C)large piece in the middle x 1

5-peel off A
6-make a cut in the middle of B and peel off short section of them towards both ends to make 4 tongues
7-peel off a part of C to make the 5th tongue
6-place the sill gently on the designated area
7-press lightly after adjusted to correction position
8-peel off the tongues one by one slowly towards both ends while keeping it in correct position
9-press evenly and firmly
10-do another door
11-done and do not wash in 24 hours

The only tricky bit (being a bit of a perfectionist) was making sure both sills lined up together but as someone pointed out you can't actually see both sills at the same time so would never know if they was not in line.

[alanr]

just ordered the door sills , will post pic when fitted

thanks for the link

[alanr]

just arrived today 8 days from HK not bad at all

sills look good will fit when it stops fecking rainning !!!!

[Lloydyboy]

Just changed the bulbs for Flux's - not the best pics will try get better ones.

Before/After


Just want to thank Flux for great communication/price/service/product! 100% recommended!

[Lloydyboy]

Not done any more mods recently but gave her a good clean, wax and polish over the weekend while the weather was nice.