Scirocco Central

One of my headlights has stopped working.

I fitted HIDs last saturday and they worked perfect for 4 days, then the right one stopped working. I checked every bit of wiring, and all the plugs and fuses. Eventually swapped everything over to the other side, and this proved that the HID bulb and ballast worked fine. So I checked for voltage and the OEM headlight plug... Nothing.

I disconnected the Battery for 15 mins then put it back together and I had 12V at the plug. hooray.

Before re-fitting the headlight, I made sure all the connections were heat-shrinked and insulated and everything was fine, and I put it back together and both headlights worked perfect.

After driving for an hour it went out again, so im stuck with one headlight still.

There seems to be condensation in the headlight that only started since I fitted the HIDs, maybe this is what is making the canbus thing shut down the power to the light.

Can anyone help me ? I will have Vagcom in a few days if that can help.

Depending how old the Scirocco is, you could experiment with turning OFF the 09 - Central Electrics Controller, Byte 23, Bit 6 - Filament test. (Won't work on MY2012 production with chassis WVWzzz13zCV000001 onwards. Its locked from that production date in a few controllers).

You'll need to clear the fault codes down in 09 Controller.

You may also need to either refit the original lamps to allow the diagnostics to settle for about 12 hours or do the battery disconnect again.

Condensation in the headlamp is irrelevant. The 09 controller is not liking the electrical load of the HID circuit you have fitted and so shutting down.

C.

So do you think Vagcom could disable the shut-down thing it does. To stop it from turning off every so often.

I have the bulb warning light on constant, with the message "check front right dipped beam".

So if the power shut-down system could be de-activated through Vagcom, then that would solve the problem, as the HIDs do work.

RW1 wrote:you could experiment with

As said, its not liking the electrical load. After disabling, it may still not like the electrical load. The units may work but that does not mean they are compatible with the Scirocco's 09- Central Electrics Controller.

C.

Its the lords way of telling you to ditch the HID;s

What kind of HID did You fit?
OEM?
Bulb replacement only?
New housing and electrics?

Its an aftermarket kit with new bulbs, ballasts and wiring.

Easy to fit. MY mate has the exact same set, he has had 2 different cars with a set in each, and both they sets have worked perfect.

So im gonna get the multimeter out and check the currents on the supply side of each ballast, then fit a resistor to one to balance out the load and see if that does the trick. (Im an electrician btw) lol.

I m not quite sure if it has been metioned before but try the following.

Put the lights switch to sidelights. Then turn the key to power up the electronics and the engine.

In a lot of simiar cases in Greece that "procedure" did the trick.

Ill give that a try if they cut out again. (I reset my battery earlier, so they are working the now)

...But for how long... :/

gkatsi wrote:Put the lights switch to sidelights. Then turn the key to power up the electronics and the engine.

They cut out again today, so I tried this, and IT WORKED

Thanks a lot mate