Page 1 of 1

Fitting skoda yeti chrome exhaust tips

Posted: Sat Feb 10, 2018 12:28 pm
by risingson
Hi, I know this has been done zillions of times before, but I'm quite late to the game!

I followed skoda's fitting instructions, so that meant putting them on with the 'slash' running exactly from top to bottom (without cutting the original tail first).

But it looks like the slash on my original tails isn't quite top to bottom but more 1.30 o'clock to 7.30 o'clock, so that it follows the curve of the rear bumper more.

So should I be fitting the tips at the same angle (i.e. twisted about 30deg clockwise?) Diy installs I've seen have the clips exactly at top, bottom, left, right - ie it's not twisted. But they don't seem to have as much of an angle running right to left where the original tail meets up.

Should I just carry on hammering, as I don't think it's inside the rolled ends yet? I didn't want to continue in case I have to hammer them back off and change the angle.

Cheers - pics below.

ImageImage

Sent from my SM-G928F using Tapatalk

Re: Fitting skoda yeti chrome exhaust tips

Posted: Sat Feb 10, 2018 4:42 pm
by Renaldo
I had a small gap on mine as well even when fully hammered in and aligned, once the carbon built up it wasn't really noticeable.


Sent from my iPad using Tapatalk

Re: Fitting skoda yeti chrome exhaust tips

Posted: Sun Feb 11, 2018 11:09 am
by risingson
Renaldo wrote:I had a small gap on mine as well even when fully hammered in and aligned, once the carbon built up it wasn't really noticeable.


Sent from my iPad using Tapatalk
Cheers renaldo, I've just trimmed down my original post as it was rambling too much! Much better weather today to finish fitting them!

Sent from my SM-G928F using Tapatalk

Re: Fitting skoda yeti chrome exhaust tips

Posted: Sun Feb 11, 2018 1:23 pm
by risingson
Thankfully they're easier to hammer on and off than I thought (if you prop the end of the car up on a kerb! [WINKING FACE]). So with some trial and error twisting them by about 30deg clockwise seemed to work best. Best £30 I've spent for a while! Before and after pics: ImageImageImageImage

Sent from my SM-G928F using Tapatalk

Re: Fitting skoda yeti chrome exhaust tips

Posted: Fri Feb 16, 2018 5:48 pm
by Renaldo
Looks awesome [emoji1360]


Sent from my iPad using Tapatalk

Re: Fitting skoda yeti chrome exhaust tips

Posted: Sat Feb 17, 2018 2:36 pm
by risingson
Renaldo wrote:Looks awesome [emoji1360]


Sent from my iPad using Tapatalk
Cheers

Sent from my SM-G928F using Tapatalk

Re: Fitting skoda yeti chrome exhaust tips

Posted: Sun Feb 18, 2018 9:32 am
by Zanic L3
Wait.. What?
These tips aren't standard? I have a 2009 2.0 TSI and they are on there exactly the same not sure if the owner fitted them after on.. Or mb they were standard on the 2.0TSI models?

Image

Re: Fitting skoda yeti chrome exhaust tips

Posted: Sun Feb 18, 2018 12:18 pm
by Cuprabob
Zanic L3 wrote:Wait.. What?
These tips aren't standard? I have a 2009 2.0 TSI and they are on there exactly the same not sure if the owner fitted them after on.. Or mb they were standard on the 2.0TSI models?

Image
They were standard fitment on 2.0 TSI and 2.0 TDI (170) models.