Scirocco Central

Do you have the mounting brackets at your hands? Is it possible to post a photo of these two? (I mean the 3WO... parts). I'm still waiting them from my dealer.

Nope my parts 3W0 parts are due in next week.

Same as mine. Waiting...

SteveP wrote:I think it will be just about possible to route the cable down to the top of the number plate recess but to fix the camera mounting bracket properly and avoiding damaging anything else when making the hole for the camera will mean the bumper removal is the best way IMHO.

Compared to the install of the camera on the Mk5 Golf, popping a bumper off is very easy unlike the tailgate trim on the Golfs.

Yeh I have just been looking on Elsa for bumper removal and it's only about 8 screws

Ryan is a bodyshop expert on here .....
Rear Bumper Removal

C.

Finally the camera mounting parts are due to arrive tomorrow at the dealers, but on the plus side thanks to DaveB for the loan of his Rocco I have been able to dry fit the plug and play wiring loom I have been working on and it all works fine.

I am excited LOL

A couple of photos from my test

Dave's car in bits



Plug and Play loom to pickup the reverse signal



The camera and main loom



And the result





The coding required is as per the Golf's, so open the Navigation (37) controller and select coding, then long coding helper, then in the forth block (byte 3) set bit 6 to on (shown as "Backup Camera Low"), close the long coding and saving the new coding. Reboot the RNS-510 by pressing the "<" & ">" & "i" button.

Also confirmed to get the camera into the ideal place, by the number plate lights, the bumper will need to be removed and a small hole drilling

nicely done steve.

Excellent Steve

C.

This is the part I have also reached. Just a question. Why do you have fullscreen view?

mantzas wrote:This is the part I have also reached. Just a question. Why do you have fullscreen view?

The view will depend on the firmware if you have an RNS or will always be non fullscreen if you have an RCD-510.

I have RNS ver B but i dont know firmware. Which firmware shows fullscreen? When fullscreen do you still have the options available?

You will have firmware 1100, DaveB's car has 2670.

The controls are available under a pop-side menu. The fullscreen view is slightly stretched but I much prefer it.

Is non fullscreen an option on newest firmwares?
Btw thanks for the info.

No you can't select the option, it will always default to fullscreen with the pop out controls.

The other change is if your car is equipped with parking sensors you get an overlay of the optic sensors on the screen as well: -

I see.. Firmware update soon then..

How do you plan to guide the wire?

In what way do you mean by guide the wire?

Where will it pass from? Under the door sills? ( sorry for my bad english)