Page 2 of 2

Re: P2015 inatke manifold flap solution?

Posted: Wed Oct 28, 2015 11:25 pm
by BadBoy
My party was £125 all in, and the injector seals are not needed

Sent from my Nexus 6P using Tapatalk

Re: P2015 inatke manifold flap solution?

Posted: Sun Nov 01, 2015 8:07 pm
by pedrotsi
Had mine replaced couldnt notice any problems when i had the fault but after it was replaced my mpg went up by about 8!!

You could leave it but from what i understand if your flaps got stuck closed you wpnt have full volume of the manifold and power will drop.

Also just because the techs cant replicate the issue doesnt mean its not there could be an intermitent fault.

Price sounds steep though i paid around €460

Re: P2015 inatke manifold flap solution?

Posted: Thu Nov 05, 2015 9:13 am
by SciroccoEire
New Manifold in...No errors yet :clap:

Re: P2015 inatke manifold flap solution?

Posted: Wed Jan 06, 2016 11:38 pm
by Solosheep
How much is this part and what is the part number?

Re: P2015 inatke manifold flap solution?

Posted: Sun Jan 17, 2016 8:01 pm
by dimexi
Sorry to revive this thread. had my car 3 years, no issues. I applied a superchips (bluefin) stage 1 today and it pops up with all sorts of errors on the intake manifold:
2 Faults Found:

Code: Select all

008196 - Intake Manifold Flap; Bank 1 
               P2004 - 000 - Stuck Open
             Freeze Frame:
                    Fault Status: 01100000
                    Fault Priority: 0
                    Fault Frequency: 1
                    Reset counter: 255
                    Mileage: 83992 km
                    Time Indication: 0
                    Date: 2001.14.21
                    Time: 14:26:05

             Freeze Frame:
                    RPM: 1088 /min
                    Load: 25.5 %
                    Speed: 0.0 km/h
                    Temperature: 2.0°C
                    Temperature: 4.0°C
                    Absolute Pres.: 1010.0 mbar
                    Voltage: 14.224 V

008213 - Intake Manifold Flap Position Sensor (Bank 1) 
               P2015 - 000 - Implausible Signal
             Freeze Frame:
                    Fault Status: 01100000
                    Fault Priority: 0
                    Fault Frequency: 13
                    Reset counter: 255
                    Mileage: 83993 km
                    Time Indication: 0
                    Date: 2001.14.21
                    Time: 14:31:16

             Freeze Frame:
                    RPM: 1945 /min
                    Load: 55.7 %
                    Speed: 39.0 km/h
                    Temperature: 57.0°C
                    Temperature: 4.0°C
                    Absolute Pres.: 1010.0 mbar
                    Voltage: 14.224 V


Readiness: 0010 0001
A bit worrying I think.. After I applied the remap, I started the engine and it felt a bit rough for about 30 secs, and then it settled down. I assume the engine was getting to grips with the new setting.. No EML for me, I will drive through the week and see if this issue is still there...

Have you all got yours replaced by an indie?

Re: P2015 inatke manifold flap solution?

Posted: Mon Jan 18, 2016 5:12 pm
by salsajoe
dimexi wrote:Sorry to revive this thread. had my car 3 years, no issues. I applied a superchips (bluefin) stage 1 today and it pops up with all sorts of errors on the intake manifold:
2 Faults Found:

Code: Select all

008196 - Intake Manifold Flap; Bank 1 
               P2004 - 000 - Stuck Open
             Freeze Frame:
                    Fault Status: 01100000
                    Fault Priority: 0
                    Fault Frequency: 1
                    Reset counter: 255
                    Mileage: 83992 km
                    Time Indication: 0
                    Date: 2001.14.21
                    Time: 14:26:05

             Freeze Frame:
                    RPM: 1088 /min
                    Load: 25.5 %
                    Speed: 0.0 km/h
                    Temperature: 2.0°C
                    Temperature: 4.0°C
                    Absolute Pres.: 1010.0 mbar
                    Voltage: 14.224 V

008213 - Intake Manifold Flap Position Sensor (Bank 1) 
               P2015 - 000 - Implausible Signal
             Freeze Frame:
                    Fault Status: 01100000
                    Fault Priority: 0
                    Fault Frequency: 13
                    Reset counter: 255
                    Mileage: 83993 km
                    Time Indication: 0
                    Date: 2001.14.21
                    Time: 14:31:16

             Freeze Frame:
                    RPM: 1945 /min
                    Load: 55.7 %
                    Speed: 39.0 km/h
                    Temperature: 57.0°C
                    Temperature: 4.0°C
                    Absolute Pres.: 1010.0 mbar
                    Voltage: 14.224 V


Readiness: 0010 0001
A bit worrying I think.. After I applied the remap, I started the engine and it felt a bit rough for about 30 secs, and then it settled down. I assume the engine was getting to grips with the new setting.. No EML for me, I will drive through the week and see if this issue is still there...

Have you all got yours replaced by an indie?
Got mine replaced by an Indie - did not want to pay VW labour rates!! so saved £150 but paid full price for the part. Can get the part cheaper from the USA if you are prepared to wait for delivery.

Re: P2015 inatke manifold flap solution?

Posted: Mon Jan 18, 2016 6:01 pm
by Roy_01
Save and erase the fault codes in the engine module. Great chance there isn't a real problem but it shows up because of the remap. If there is a real problem it will return.

Re: P2015 inatke manifold flap solution?

Posted: Mon Jan 18, 2016 9:06 pm
by dimexi
Thanks for the advice salsajoe. How much did it cost in total? I know a few indies to call - I'd rather get it sorted soon, just cos I am concerned that it says "flap stuck open"

@roy - I did erase them, and they have returned today :(((, exactly the same ones.. I have other errors now, but I will post them in another thread.
Oh, and my Engine Check light is also on now :(

Re: P2015 inatke manifold flap solution?

Posted: Mon Jan 18, 2016 9:22 pm
by Roy_01
Did you erase them in the engine module itself? You cant erase them with a full scan and clear dtc's.
I would return to the tuner and let them fix it, very obvious that this all happens 1 day after tuning.
Did they deliver it without fault codes?

Re: P2015 inatke manifold flap solution?

Posted: Mon Jan 18, 2016 10:10 pm
by dimexi
Yeah, I went into the engine module to delete the codes - and tonight when I scanned, it reappeared.

It was a superchips/bluefin remap. So I just followed the instructions on their handset - I might send them an email and see what they say. I doubt the manifold will go back to normal if I take off the map

EDIT: I have sent superchips an email, no response yet. I have had a quote from one indie to replace the manifold, he is quoting about £570 :cry: :fall:

Re: P2015 inatke manifold flap solution?

Posted: Fri Jan 22, 2016 11:46 am
by dimexi
Update: part arrived yesterday from europaparts, not opened it, but I'm sure all is intact. It cost £173. I ordered it on Tuesday afternoon, and it arrived Thursday morning from America (not a long wait at all).
Got an indie I can trust who can fit it for 80£+vat. So I think I've got away with a good saving. Thanks for all your help guys.
I was told the car is safe to drive, and the problem would have been if the valve was stuck closed (and not open).

I'll update again once the part has been fitted